krick FOLKEBOOT Baubeschreibung Seite 82

until the resin takes on a paste-like consistency
and therefore no longer runs through the gaps.
After this step, the hull is also protected
against water ingress.
Stage 3, deck, superstructure and cockpit
Now fit the two superstructure side sections
3.2 as a test and lay the deck. Mark the cut-out
for the forestay fitting.
Fig.: Insert body sides
Fig.: Marking the section
Cut out the recess for the foresail fitting. Drill
two small holes and cut out the gap with a
sharp knife.
Make the forestay fitting from the sheet metal
strip 2.58 according to the drawing. Bend the
ends so that the fitting cannot be pulled out
upwards.
Fig.: Forestay fitting
Status October 2024
The two superstructure sides 3.2 can now be
glued in place.
Fig.: Glueing the superstructure sides
To ensure that the deck rests securely, cut off
pieces of strip 2.44 on the inside of the ends of
the superstructure sides and glue them in
place.
Fig.: Support at the front
Fig.: Support at rear
The two parts of the superstructure rear panel
3.4 can now also be fitted and glued in place.
Seite 10
3.2
©
Krick Modelltechnik, Knittlingen, Germany