krick FOLKEBOOT Baubeschreibung Seite 79

Fig.: Strips glued on
The strips can be fixed to the bow using small
screws. The screw holes can later be sealed
with wooden dowels (e.g. toothpicks).
Fig.: Closing the screw holes
Also glue and sand the end strip 2.25 to the
rear.
2.25
Fig.: End strip (picture small Folkeboot)
Fig.: Bow strips sanded
Status October 2024
Once everything has been sanded down, light-
coloured areas have reappeared, which can
now be re-stained.
Fig.: Deck frame and support
Install the deck frame and the two stabilisers.
Glue the supports 2.50 in the transom and
frame 14 (part 2.21). Fit and glue the stern
bulkhead 2.49.
In the next step, install the support strips 2.45
and 2.46 for the deck and 2.51 and 2.52 for the
cabin walls.
2.51
2.45
Fig.: Support strips
2.46
Fig.: Reinforcement of foresail fitting
Fit and glue in the two reinforcement strips
2.46.
The next step is to insert the upper mast
bearing.
Seite 7
2.46
©
Krick Modelltechnik, Knittlingen, Germany
2.49
2.50
2.52