Heart Rate Graph Frame (Fhr Graph Frame); Uc Numeric Frame (Toco Numeric Frame); Uc Graph Frame (Toco Graph Frame); Power Status Frame - Medical Econet Ecotwin Lcd Bedienungsanleitung

ECOtwin LCD / LED

Heart Rate Graph Frame (FHR Graph Frame)

The Heart Rate (FHR) Graph Frame displays a graphical representation of the fetal heart rate. The
vertical scale is labeled and corresponds to the recorder paper (30 to 240 BMP). The graph displays
4 minutes and 30 seconds of data regard less of print speed.
This frame will show two heart rate trends when two ultrasound transducers are installed.
Two or three horizontal graticules are included to make it easier for the caregiver to observe heart rate
trend or heart rates that exceed limits. For the FS151-90-80R-01 paper, three graticules are
indicated on 100, 140 and 180 BPM. For the M1911A paper, two graticules are indicated on 120 and
160 BPM. This graphical frame is also used to display heart rate data when scrolling through
historical patient data.

UC Numeric Frame (TOCO Numeric Frame)

This frame contains the numeric value from the UC transducer representing uterine contraction. This
frame also shows the present UC baseline value. The UC baseline is user adjustable.

UC Graph Frame (TOCO Graph Frame)

The UC Graph Frame displays uterine contraction graph data. The scale is from zero to 100 in
relative units. The graph displays 4 minutes and 30 seconds of data regardless of print. This
graphical frame also displays uterine contraction data when scrolling through patient data.

Power Status Frame

This frame contains either a battery icon or an AC power connector icon. If the unit is operating on
AC power then an AC power connector icon is displayed. If the monitor is operating on internal
battery power then a battery icon is displayed. The battery icon also includes a scale indicating
battery charge status. If AC power is disconnected, ECOTWIN uses the internal battery. Therefore
in the case of AC power is disconnected, there is no problem to use ECOTWIN.
The battery icon will flash when the battery is low (less than 10 minutes of remaining time). Printer
will stop operation in case Low Battery and the battery icon will turn on RED.
The AC power should be connected to the monitor to charge the battery. The monitor will operate
normally while the AC power is charging the battery. The battery will be fully recharged in 14 hours
if the monitor is not in use, or in 14 hours while in normal use.

Status Frame

This frame shows printer speed set, printer operating status, zoom in status, auto printing status, and
saving status.

Patient ID

This section displays the patient identification. The monitor uses a time and date encoded
identification scheme that insures no duplication of names. The user may also enter a different name
if desired.

Time and Date

This frame shows the current time and date for the monitor. These settings can be changed as needed.
User manual
20