Control Knob; System Setting; Setting Alarm Upper Limit / Lower Limit - Medical Econet Ecotwin Lcd Bedienungsanleitung

ECOtwin LCD / LED

Control Knob

The Control Knob is the primary method of adjusting parameters and navigating through the menu
system. If the knob is rotated to the CW (clockwise) or CCW (counterclockwise) while in system
setting, the setting display will be changed. This process is used to select a setting item for
modification. The knob is then pressed to select this item for editing.
Once a setting item has been selected for editing, the knob is rotated to scan through the available
choices for this parameter. Pressing the knob stores the new value temporarily.

System Setting

The following section describes the procedure used to set alarm parameters and system setting.
Activity
Knob Press
Knob Rotate
Knob Press
Knob Rotate
Knob Press

Setting Alarm Upper Limit / Lower Limit

Activity
Knob Rotate
Knob Press
Knob Rotate
Knob Press
User manual
Desired Result
Enter the setup mode.
Select setting value.
Select this parameter for change.
Change the desired value.
Store the new value.
Fig. 5.3 Alarm Upper /Lower Limit
Desired Result
Select "hi" or "Lo"
Select this parameter for change.
Change the desired value.
The list below shows the values that are available for each
parameter:
Heart Rate Upper Limit { (Heart Rate Lower Limit +10)–240 BPM, 5 BPM
increments}
Heart Rate Lower Limit {30–(Heart Rate Upper Limit-10) BPM, 5 BPM
increments}
Store the new value.
36