Power On; Patient Cables; Event Marker Cable - Medical Econet Ecotwin Lcd Bedienungsanleitung

ECOtwin LCD / LED

Power On

When the user wants to turn ECOTWIN on, power adaptor is connected with power adaptor jack connector
on left panel of ECOTWIN as shown in Figure 3.2 and power button is pressed.

Patient Cables

The ultrasound and TOCO transducer cable are connected to the right panel. Each transducer has a
label (DOP or UC) to insure proper connection to the exact connector on the monitor. Also each
connector in the right panel has a label (DOP1 or UC) to insure proper cable connection.
The cables are connected or removed by putting into the connector tightly or pulling out of the
connector. There is no connector locking mechanism.
Another ultrasound transducer is supplied with the ECOTWIN capable of monitoring two fetuses by
connecting this to DOP2 connector.
WARNING
Use only patient cables and transducers supplied with the monitor. Use of any other patient

cables may result in out-of-specifications performance and possible safety hazards.

Event Marker Cable

The event marker cable is connected to the connector in the left panel. The label on the housing
shows the location of the connector. The cable is connected by putting into the connector tightly.
There is no connector locking mechanism.
WARNING
SHOCK HAZARD — Power receptacle must be a three -slot grounded outlet. If the outlet

has only two slots, make sure that it is replaced with a three-slot grounded outlet before
attempting to operate the monitor.
Do not connect to an electrical outlet controlled by a wall switch.

SHOCK HAZARD — Do not attempt to connect or disconnect a power cord with wet hands.

Make certain that your hands are clean and dry before touching a power cord.
User manual
12