General Safety Information; Symbols Used - Medical Econet Ecotwin Lcd Bedienungsanleitung

4
ECOtwin LCD / LED

General Safety Information

Before using ECOTWIN, read all section of this manual carefully because there are additional warnings and
cautions which relate to specific features of the monitor.
The warnings and cautions in this section relate to the equipment in general and apply to all aspects of the
monitor. The listed order does not imply any order of importance.
Observe all precautions to ensure the safety of the patient and those near the instrument.

Symbols Used

The following symbols identify all instructions that are important to safety. Failure to follow these
instructions can lead to injury or damage to the ECOtwin. When used in conjunction with the
following words, the symbols indicate:
EXPLOSION HAZARD — Do not use the ECOTWIN in a flammable atmosphere

where concentrations of flammable anesthetics or other materials may occur.
SHOCK HAZARD — The power receptacle must be a three-wire grounded outlet.

Never adapt the three-prong plug to fit a two-slot outlet. If the outlet has only two
slots, make sure that it is replaced with a three-pole grounded outlet before attempting
to operate the monitor.
Do not connect to an electrical outlet controlled by a wall switch.

SHOCK HAZARD — Do not attempt to connect or disconnect a power cord with wet

hands. Make certain that your hands are clean and dry before touching a power cord.
Use only patient cables and transducers supplied with the monitor. Use of any other

patient cables may result in out-of-specification performance and possible safety
hazards.
Do not contact RS-232C port and patient at the same time.

AC/DC Adaptor should use appointed product.

SHOCK HAZARD — Do not attempt to disjoint the power adaptor exterior with no

permission. It may cause electric shock. Also, it has low possibility of reaching to
death. In the case of problems with the power adaptor, we recommend you to contact
us.
SHOCK HAZARD — Do not touch the patient simultaneously with contacting signal

connector, other equipment or ground. This can cause the electric shock to the patient
or operator.
SHOCK HAZARD — During upgrading the ECOTWIN, do not use the ECOTWIN to

the patient. This can cause the electric shock to the patient.
User manual
Be informed that it may cause serious injury or death to the
WARNING
patient, property damage, and material losses.
CAUTION
Be informed that it may cause no harm in life but lead to injury.
Background information provided to clarify a particular step or
NOTE
procedure.
WARNING
4