Detail Procedure - Medical Econet Ecotwin Lcd Bedienungsanleitung

ECOtwin LCD / LED

Detail Procedure

Explain procedure to the patient.
①
Place a probe belt under the patient
②
Turn the monitor power on. The power switch is located on the rear panel. The green indicator
③
located under the left side of the printer door illuminates when the power on.
Connect the transducer plug to "UC" connector located on the underside of the front cover.
④
Note: When connector or re-connecting the UC probe to the monitor's UC connector,
you must wait at least 10 seconds before depressing the UC reference [
Briefly depress the UC reference [
⑤
Position UC probe on the maternal abdomen over the uterine fundus or where there is the least
⑥
maternal tissue and the contractions are strongly palpated.
Connect each end of the belt to the transducer by inserting the transducer button through a
⑦
buttonhole on the strap. Select a buttonhole that ensure a comfortable fit and holds the transducer
securely in the place.
Between contractions, depress the UC reference [
⑧
The monitor is now ready to begin monitoring.
⑨ If not already activated, depress the [
The recorder plots the UC on the paper strip chart.
CAUTION
The probe belt may cause allergy or skin side effects to patient, if it is used so long time.

User manual
] pushbutton to set the UC baseline at 10.
] button again. This set UC baseline to 10.
] pushbutton located on the front panel of the monitor.
] button.
53