medical ECONET ECOtwin LCD Bedienungsanleitung Seite 87

5
ECOtwin LCD / LED
The equipment conforms to Class I according to IEC/EN 60601-1(Safety of Electric

Medical Equipment)
This equipment conforms to Level B according to IEC/EN 60601-1-2

(Electromagnetic Compatibility Requirements)
The relevant law restricts this device to sale by or on the order of a physician.

Keep the operating environment free of dust, vibrations, corrosive, or flammable

materials, and extremes of temperature and humidity. The unit should be kept clean
and free of transducer gel and other substances.
When installing the unit into a cabinet, allow for adequate ventilation, accessibility for

servicing, and room for adequate visualization and operation.
Do not operate the unit if it is damp or wet because of condensation or spills. Avoid

using the equipment immediately after moving it from a cold environment to a warm,
humid location.
Never use sharp or pointed objects to operate the front-panel switches.

General-purpose personal computers and modems are not designed to meet the

electrical safety requirements of medical devices. The RS-232C connector on the
ECOTWIN is electrically isolated to permit safe connections to non-medical devices,
which should be connected with a cable of sufficient length to prevent the non-medical
equipment from contacting the patient. If the ECOTWIN have to be connected to another
medical devices, it must be complied with the standards IEC/EN 60601-1 and IEC/EN
60601-1-2.
Do not autoclave or gas sterilize the monitor or any accessories. Follow cleaning and

disinfection instructions in Section 9 of this manual.
Do not immerse ECOTWIN main body and transducers in liquid. When using

solutions, use sterile wipes to avoid pouring fluids directly on the transducer. Follow
cleaning and disinfection instructions in Section 9 of this manual.
When washing the transducer belts, the water temperature must not exceed 60°C

(140°F).
When loading paper, the paper must be put above the shaft. Otherwise, the paper can

be biased one side.
If the equipment is used in area where the integrity of the external protective

conductor in the installation or its arrangement is in doubt, equipment shall be
operated from its internal electrical source when the optional battery is selected.
When the printer door is open, do not put the finger to the inside of ECOTWIN. This

can cause the finger wound. Also do not prick the inside of ECOTWIN when the
printer door is open. This can cause the damage to the device or electric shock.
User manual
CAUTION
5