Scheppach HC54 Originalbetriebsanleitung Seite 30

• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the device, the fuel tank and the
motor oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in an
environmentally friendly manner.
12. Troubleshooting
Fault Possible cause
The compressor does not start.
Mains voltage too low.
The compressor
does not start.
Outdoor temperature too low.
Motor is overheated.
Safety valve (8) leaking.
Compressor runs, The seals are damaged.
but no pressure.
The drain screw for condensate (10)
leaks.
Hose connections leaking.
Compressor
running, pressure
shown on the
Quick-coupler leaking.
manometer, but
tools are not
Pressure set too low at pressure
running.
regulator (5).
30 | GB
Remedy
Check cable, mains plug, fuse and socket.
Avoid extension cables that are too long. Use
extension cables with sufficient conductor
cross-section.
Do not operate at outside temperatures below
+5°C.
Let the motor cool down, if necessary, eliminate
the cause of overheating.
Replace the safety valve (8).
Check the seals and have any damaged seals
replaced by a service centre.
Tighten the screw by hand. Check the seal on
the screw and replace if necessary.
Check compressed air hose and tools, replace
if necessary.
Check quick coupling, replace if necessary.
Turn up the pressure regulator further.
www.scheppach.com