Scheppach HC54 Originalbetriebsanleitung Seite 25

• Wear safety goggles and a respirator when working
with the compressed air pistol. Dusts are harmful to
health! Foreign objects or blown off parts can easily
cause injuries.
• Do not blow on people or clean clothing whilst on
the body with the air blow gun. Danger of injury!
Safety instructions when using spraying attach-
ments (e.g. paint sprayers):
• Keep the spray attachment away from the compres-
sor when filling so that no liquid comes into contact
with the compressor.
• Never spray in the direction of the compressor when
using the spraying attachments (e.g. paint sprayers).
Moisture can lead to electrical hazards!
• Do not process any paints or solvents with a flash
point below 55° C. Risk of explosion!
• Do not heat up paints or solvents. Risk of explosion!
• If harmful liquids are processed, filter devices (face
masks) are required for protection. Also observe the
information on protective measures provided by the
manufacturers of such substances.
• The information and labelling of the hazardous sub-
stances ordinance affixed to the outer packaging of
the processed materials must be observed. If neces-
sary, take additional protective measures, in particu-
lar wear suitable clothing and masks.
• Do not smoke during the spraying process or in the
working area. Risk of explosion! Paint vapours are
also highly flammable.
• Fireplaces, naked flames lights or sparking machin-
ery must not be present or operated.
• Do not store or consume food or drinks in the work
area. Paint fumes are harmful to health.
• The working area must be larger than 30 m³ and suf-
ficient air exchange must be ensured during spray-
ing and drying.
• Do not spray into the wind. Always observe the reg-
ulations of the local police authorities when spraying
flammable or hazardous spraying materials.
• Do not use media such as white spirit, butyl alcohol
and methylene chloride in conjunction with the PVC
pressure hose. These media destroy the pressure
hose.
• The work area must be separated from the compres-
sor so that it cannot come into direct contact with the
working medium.
Operation of pressure vessels
• Anyone who operates a pressure vessel must keep
this in good working order, operate and monitor it
correctly, perform the necessary maintenance and
servicing works immediately and implement safe-
ty measures as required according to the circum-
stances.
• The regulatory authority can instruct necessary
monitoring measures in individual cases.
• A pressure vessel must not be operated if it exhib-
its a defect that poses a danger to personnel or
third parties.
• Check the pressure vessel for rust and damage
each time before use. The compressor shall not be
operated if the pressure vessel is damaged or rusty.
If you discover damage, please contact the custom-
er service workshop.
Store the safety instructions safely.
Residual risks
Comply with the stipulated maintenance and safety in-
structions in the operating instructions.
Remain attentive at all times when working, and keep
third parties at a safe distance from your work area.
Even when the device is being used properly, there will
always be certain residual hazards that cannot be com-
pletely ruled out. The following potential hazards can
arise due to the type and design of the device:
• Unintentional starting up of the product.
• Damage to hearing if the stipulated hearing protec-
tion is not worn.
• Dirt particles, dust etc. can get irritate the eyes or
face despite wearing safety goggles.
• Inhaling swirled up particles.
6. Technical data
Mains power connection
Engine output
Operating mode
Compressor speed
Pressure vessel volume
Operating pressure
www.scheppach.com
230 V~ 50Hz
1100 W
max. 1500 W
S1
2.850 rpm
50 l
approx. 8 bar
GB | 25