Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
properly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables with the designation H07RN.
The printing of the type designation on the connec-
tion cable is mandatory.
For single-phase AC motors, we recommend a fuse
rating of C 16A or K 16A for machines with a high
starting current (from 3000 watts)!
3-phase motor 400 V / 50 Hz
Mains voltage 400 Volt / 50 Hz.
Mains power connection and extension leads must
be 5-core = 3 P + N + SL. - (3/N/PE).
Extension cables must have a minimum cross section
of 1.5mm².
The mains power connection must be protected with
a max. 16 A fuse
When connecting to the mains or in the event of the
machine being moved to another location, the turning
direction must be checked. It may be necessary to
change the polarity.
Turn the pole changing device in the device connector.
12. Cleaning
Attention!
Disconnect the mains plug before carrying out any
cleaning work.
We recommend that you clean the device directly af-
ter every use.
28 | GB
Wipe swarf and dust off the machine from time to time
with a cloth.
Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can pen-
etrate the device interior.
13. Transport
The firewood splitter can be easily transported using
the 3-point attachment on the drive vehicle.
Before transporting the firewood splitter, place it in
the transport position. To do this, move the riving
knife downwards until it rests on the metal support.
Then remove both L-pins and move the hydraulic cyl-
inder down into the transport position by pressing the
return bow downwards.
Make sure there is sufficient manoeuvring space
when driving, e.g. when turning, parking and at junc-
tions.
Before transport, ensure that the firewood splitter is
properly and securely attached to the drive vehicle
and that the cardan shaft has been disassembled.
Never transport the firewood splitter with the
cardan shaft drive connected.
Make sure that the firewood splitter is raised high
enough to pass obstacles during transport.
14. Storage
Store the device and its accessories in a dark, dry
and frost-free place that is inaccessible to children.
The optimum storage temperature lies between 5 and
30 ˚C.
Store the tool in its original packaging.
Cover the tool to protect it from dust or moisture.
Store the operating manual with the tool.
15. Maintenance
Attention!
Disconnect the mains plug before carrying out any
maintenance work. Ensure that the cardan shaft is
not connected to the drive vehicle.
When do I change the oil?
Initial oil change after 50 operating hours, then every
250 operating hours.
Oil change (Fig. 18)
Place the firewood splitter on a slightly raised surface
(e.g. Euro pallet). Set a sufficient container (min. 30
litres) under the drain screw on the splitting column.
Open the drain screw and carefully allow the oil to run
into the container.
www.scheppach.com
Werbung
