Kyosho MINI-Z Buggy MB-010 Serie Bedienungsanleitung Seite 39

TROUBLE
Problem /
Model doesn't move
Loss of Control
SHOOTING
Cause/
Transmitter or chassis power switch is
not ON.
Polarity or battery type is wrong
Batteries have run low.
Circuit protection operates.
Pairing is cancelled
Using a different transmitter.
LED on chassis is flashing
LED on chassis takes a long time to
light up.
FWD and REV control are opposite.
Left and right control are opposite.
Batteries have run low.
Antenna is not straightened
Other devices using 2.4GHz are being
used close by.
2
Main road or large steel pylon is nearby.
Front Wheels vibrate side
/
Correction
Switch power on as per Instruction
Manual
Check polarity and type as per Instruction
Manual
Change batteries
Manual
Please
Protection"
Complete the pairing process again as per
Instruction
Refer to pages 16-20 and complete pairing
(binding)
Switch transmitter
After 5 seconds,
Other
area may cause a delay. This is not a fault.
Refer to "switching
section
Refer to "Reverse Steering Direction"
section
Change batteries as per Instruction
Manual
Straighten up antenna on transmitter and
up
chassis.
Operate
stop using the other device.
Run model
Due to high performance digital servo some
to side.
vibration may occur. This is not a fault
39
! ?
/
P21 - 23.
P 14.
as per Instruction
P14.
refer to the "MINI-Z Series
section in the Technical
manual P 16 - 20.
and chassis power OFF.
switch power back ON.
2.4GHz devices or transmitters
Forward and Reverse"
on the Technical Guide
on the Technical Guide
P.14.
model in a different area, or
in different area.
Circuit
Guide.
in the