Clean Air Cooling System; Engine Adjustments; Storage; Storage Instructions For Your Engine - Hecht 8573 Originalbetriebsanleitung

3. After all the fuel has drained into the container, reinstall the drain bolt and washer. Tighten
the drain bolt securely.

CLEAN AIR COOLING SYSTEM

WARNING! Running engines produce heat. Engine parts, especially muffler, become
extremely hot. Severe thermal burns can occur on contact. Combustible debris,
such as leaves, grass, brush, etc. can catch fire.
• Allow muffler, engine cylinder and fins to cool before touching.
• Remove accumulated debris from muffler area and cylinder area.
NOTICE: Do not use water to clean the engine. Water could contaminate the fuel
system. Use a brush or dry cloth to clean the engine. This is an air cooled engine. Dirt
or debris can restrict air flow and cause the engine to overheat, resulting in poor
performance and reduced engine life.
Use a brush or dry cloth to remove debris from the finger guard. Keep linkage, springs and
controls clean. Keep the area around and behind the muffler free of any combustible debris.

ENGINE ADJUSTMENTS

NOTE: Do not change in any way the rated speed of the engine (carburetor side or
regulator side).
Your engine was adjusted in the factory and the non-respect of the homologation speed engine
could be dangerous for your safety and others safety. If the motor settings is changed in any
way, the warranty will be cancelled. If additional adjustment is necessary (eg. for high altitude),
contact authorized service center!

STORAGE

CAUTION! The engine must have completely cooled down before storing the
machine.
• Never store the equipment with petrol in the tank inside a building where fumes can reach an
open flame or spark.
• Allow the engine to cool before storing in any enclosure.
• Replace worn or damaged parts for safety. Use only original spare parts
• If the fuel tank has to be drained, this should be done outdoors.

STORAGE INSTRUCTIONS FOR YOUR ENGINE

Caution: Never store engine in vicinity of stoves ovens water heaters with pilot
light contingently other devices which can produce sparks.
STORAGE.PREPARATION
Proper storage preparation is essential for keeping your engine trouble free and looking good.
The following steps will help to keep rust and corrosion from impairing your engine's function
and appearance, and will make the engine easier to start when you use it again.
EN
DE
CS
SK
PL
35 / 148