Residual Risks; Electrical Requirements - Hecht 8573 Originalbetriebsanleitung

If petrol or oil comes in contact with the eyes, wash them immediately with clean water. If
EN irritation is still present, see a doctor immediately.
• Individuals with poor circulation who are exposed to excessive vibration may experience injury
to blood vessels or the nervous system. Vibration may cause the following symptoms to occur
in the fingers, hands or wrists: "Falling asleep" (numbness), tingling, pain, stabbing sensation,
alteration of skin colour or of the skin. If any of these symptoms occur, see a physician!
Put safety first in the case of fire:
DE
• If fire comes from the engine or smoke appears from any area other than the exhaust vent, first
distance yourself from the product to ensure your physical safety.
• Use foam fire extinguisher on the fire to prevent it from spreading.
• A panicked reaction could result in the fire and other damage becoming more extensive.

RESIDUAL RISKS

CS
• Even if the device is used according to instructions, it´s impossible to eliminate all the risks
associated with its operation. The following risks may occur arising from device construction:
• Mechanical hazard, caused by cut and throw off.
• Electrical hazard caused by touch with parts under high voltage (direct contact) or with parts,
which came under a high voltage due to failure of the device (indirect contact).
• Heat hazard resulting in burning or scalding and other injuries caused by possible contact with
high temperature objects or materials including heat sources.
SK
• Noise risk resulting in loss of hearing (deafness) and other physiological disorders (e.g. loss of
balance, loss of consciousness)
• Vibration risk (resulting in vascular and neurological harm in the hand-arm system, for example
so called "white finger disease")
• Dangers caused by contact with harmful liquids, gas, mist, smoke and dust or by their inhalation,
relate to emissions (for example breathing in).
PL
• Danger of fire or explosion relate to spilling of fuel.
• Dangers caused by failing in ergonomic principles by construction of the machine, for example
dangers caused by unhealthy position of body or excessive overcharge and unnature to the
anatomy of the human hand-arm, relate to construction of handle, equilibrium of the machine
and using of toothrest.
• Dangers caused by unexpected starting, unexpected exceeding of engine revs caused by defect/
failure of control system, relate to the defects by the handle and placing of drivers.
• Dangers caused by impossibility to stop the machine in best conditions, relate to solidity of the
handle and placing of engine shut down device.
• Dangers caused by defect of machine control system, relate to solidity of the handle, placing
of drivers and marking.
• Dangers caused by tearing (of the chain) during running.
• Dangers caused by shooting up of subjects or splashing of liquids.

ELECTRICAL REQUIREMENTS

• Connect the device only on the plug with a protective device to prevent stray current (FI switch)
with a rated fault current of not more than 30 mA.
• Only connect the equipment to a properly grounded outlet with the specified voltage 230V/50Hz
and fuse protection.
• Always use an extension cable with a cross section that corresponds with the power input of
device and the cable length.
• Cable drum before using completely unwind. Make sure the cord is not damaged.
24 / 148