Height Adjustment Instructions; Drive Control; Emptying The Bag; Using The Machine - Hecht 8573 Originalbetriebsanleitung

STOPPING THE ENGINE
Having finished the work let the engine run for few minutes.
In case of long operation break (after season) is recommended to mix additive to fuel as
a prevention of fuel deterioration and problems with restarting in the beginning of next
season. Do not use the fuel which is older that 14 days.

HEIGHT ADJUSTMENT INSTRUCTIONS

The height of the front wheel can be set depending on the state of the surface.
1. Press and hold lever (fig. 14A) for height adjustment.
2. Tilt product to required working height.
3. Release lever for height adjustment. The front wheel locks at the set height (fig. 15A).

DRIVE CONTROL

1. Grip the Self-drive control handle (fig. 14B), the machine will move forward automatically.
2. Release the Self-drive control handle until the machine doesn't go forward.

EMPTYING THE BAG

Caution: Always empty the collection bag after stopping the engine.
1. Turn off the engine.
2. Open zipper (fig. 16A) on the rear side of the bag.
3. Empty the waste from the bag.
4. Close the zipper on the bag.

USING THE MACHINE

Do not attempt to pick up wet debris, allow fallen leaves etc, to dry out before using the machine.
When the using the machine, the debris is sucked up the suction tube before being ejected into
the debris collection bag, as the debris passes through the suction fan it is partially shredded. The
shredded organic debris is ideal to use as mulch around plants.
Warning! Any hard objects, such as stones, tin cans glass etc, will damage the
suction fan.
Important Do not use the machine to suck up water or very wet debris. Never
operate the machine without the debris collection bag fitted.
• Inspect the area to be worked before starting carefully. Remove any objects or debris that could
be thrown, jammed or become entangled in the machine.
• Organic materials such as leaves contain a large amount of water that can cause them to stick
to the inside of the suction tube. To reduce sticking the material should be left for a few days
to dry out.
ELECTRIC AND MANUAL START
Throttle lever push to „Turtle" symbol (stop).
Switch turn to OFF position.
Turn the fuel valve - if equipped - to "OFF" position.
EN
DE
CS
SK
PL
29 / 148