Call Up Via Function Menu; Call Up Via Keyboard Combination; Advices For Setting The Ivt - G&D CATVision Installation Und Bedienung

Guntermann & Drunck GmbH
5.4.2.1

Call up via Function Menu

For calling up the IVT mode open the function menu with
(Default).
F u n c t i o n
F2: IVT
F3: Console Setup
F6: Config
F8: Logout
Mouse Utility
System Info
Esc
Move the cursor to the entry IVT or confirm with
the IVT window will open.

5.4.2.2 Call up via Keyboard Combination

For directly calling up IVT keep
When both keys are released the IVT window opens (A PC must be connected
to the system).
5.4.3

Advices for Setting the IVT

The previously mentioned steps are to be understood as a default
Because the quality of the picture is dependent on the monitor as well as on the
graphics card and the transmitting cable it is possible that despite a cable
length of e.g.120 meter the "best picture" is reached with a setting of 140 meter.
Meter stands as a synonym for the adjustable video boost.
Try for the best setting.
cursors
Because the
in order to get the best picture within the fine tuning.
If your monitor stays dark, check whether the set resolution of the graphics card
is supported by the monitor. If so, activate the IVT
Possibly the supported range is exceeded or undercut. Set the lowest value
Pos1
with the key
Cursor Right.
The picture will then appear again and you can change for the best setting.
CTRL pressed and additionally press Scroll.
proceeding.
work in 1m steps you may have to press them more often
and move upwards with the HotKey-combination
page 21
Operating Instructions
CATVision (MC)
CTRL + NUM
C V M
Enter
F2 and press ENTER. Then
(chapter 5.3.2).
CTRL+