Establishing The Power Supply; Start-Up - G&D LwLVision-USB 2.0 Installationsanleitung

Establishing the power supply

RS 232 Micro In Speaker
Trans.
Service Tx Rx USB 2.0 Devices
Main Power: Insert the supplied power cable.
Use this interface to connect an optional external power pack for a sec-
Red. Power:
ond, redundant power supply.

Start-up

After both the computer module and the user module have been properly installed,
the LwLVision-USB 2.0 system can be immediately put into operation.
Turn on the power switch at the user module (LwLVision-Rem), the computer modu-
les (LwLVision-PC ) and computer connected to the computer module.
ADVICE: After the system has been turned on, the LEDs on the front panel of both
the computer module and the user module signal the system's operating status.
Further information regarding the LEDs is given in the chapter Status displays on
page 13 ff.
Keyb. PS/2 Keyb. USB
Mouse Mouse
VGA Out DVI Out Red. Power
USB 2.0 Trans.
Tx Rx
G&D LwLVision-USB 2.0 · 11
Start-up