Changing Video Channels; Automatic Settings - G&D CATVision Installation Und Bedienung

Guntermann & Drunck GmbH

5.4.4.1 Changing video channels

This function is only with CATVision-MC-Systemen available.
I V T
A c t i v e c h a n n e l : 1
The entry "active channel" refers to the corresponding used video channel.
The channels can be selected via pressing the keys
Confirm with ENTER.

5.4.4.2 Automatic Settings

You can establish all video settings automatically. To do so, you must be
connected to a target.
To activate this function, press the
channel are being established automatically, the monitor turns black for approx.
3 seconds.
With the F6 key the settings will be established for all channels (only with
CATVision-MC systems). In this case, following message appears on your
monitor:
I n f o
Automatic Video Tuning
status
Channel 1: ok
Channel 2: not connected
Channel 3: in progress
Channel 4: wait
Please wait
Whilst the automatic measuring this windows informs you about the process of
the respective measurement.
1 to 4.
F5 key. While the settings for the active
page 23
Operating Instructions
CATVision (MC)
C V M
C V M