Keyb. Led Flash; Defining The Local Scan Code; Defining The Remote Scan Code; Usb Multimedia Keyboard - G&D CATVision Installation Und Bedienung

Guntermann & Drunck GmbH
6.2.2.9

Keyb. LED flash

With this setting you define whether the keyboard LEDs will flash after activated
hold function (see chapter
Move the cursor to the entry Keyb. LED flash.
SPACE
By pressing
For saving the settings and closing the menu press F1.
6.2.2.10

Defining the local Scan Code

The scan code is the language with which keyboard and computer
communicate. CATVision works with Scancode 2 (Default).
Only change this setting in accordance with our service department.
Move the cursor to the corresponding entry.
SPACE
By pressing
For saving the settings and closing the menu press F1.
6.2.2.11

Defining the remote Scan Code

Function according to
remote console.
6.2.2.12

USB Multimedia Keyboard

By selection of the entry USB Multimedia Keyboard the USB multimedia
support for keyboards will be activated. In Default this setting is not activated
(NO).
For saving the settings and closing the menu press F1.
6.2.2.13

USB SUN Keyboard mode

If you connect a SUN computer with USB keyboard (and mouse) at CATVision-
CPU, adjust this setting to yes.
At default the support for USB SUN Keyboards is deactivated.
7.3) or Protected Mode (see
you can chose between Yes or NO.
you can select between 3 or 2.
chapter 6.2.2.10 but related to the keyboard at the
page 41
Operating Instructions
CATVision (MC)
chapter 7.4) or not.