Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Selecting the Output Image
1
Touch to select the image to print.
To cancel the selection, touch the image again. To
select all of the images, touch the [Select All/
Deselect All] button. To select or de-select more
than one image (but not all) touch them
individually, one at a time.
If all the images cannot be displayed on one screen
page, touch the [b] or [B] button to display more
pages.
At this step you can also use another button.
• With an image selected, touch the [Magnify]
button to switch to the image enlargement screen.
2
After you have selected all the images for printing,
touch the [Continue] button in the lower right
corner of the screen.
The next screen allows you to select the number of
copies for printing.
Selecting the Number of Copies to Print
1
Select the number of copies to print.
If the list contains more than one page, touch [b]
or [B] to change the page display.
• In order to select the number of prints for each
image, touch an image to select it, and then at
[Quantity] touch the [+] button or [-] button to
increase or decrease the number of copies.
• In order to set the same number of copies for all
the images, at [Add to All] touch the [+] or [-]
button to increase or decrease the number of
copies to print for all the images.
At this step you can also perform the following
procedures:
• You can edit the image by adjusting the
brightness or contrast, or trimming the image. For
details, see "Editing Image Data". (page 24)
• When the index print setting is enabled in the
Configuration Utility, you can specify whether or
not to print an index print of the displayed
images. For details, see "Using Index Printing".
(page 32)
2
Touch the [OK] button.
The following screen allows you to confirm the
calculated charge for the print job.
Information display
(Allows you to confirm the number
of prints and the calculated total
charge for the print job.)
9
Werbung
