Sony UPA-PC100 Benutzerhandbücher Seite 19

Scanning the Film
Selecting the Number of Copies to Print
At this step you can trim the image or correct its color. For details, see "Editing Image Data". (page 24)
Confirm and output charges
How to Scan Film and Print
This section describes how to scan a picture from film
as image data and then print it.
Be sure to follow the steps in order.
• Select the Scanner as the Input Device
• Selecting the Output Service
• Entering the Password and Job ID
• Setting the Film and Prescanning
• Canceling the Selected Test Image and Setting the
Scanner
• Scanning the Film
• Selecting the Number of Copies to Print
• Confirming and outputing charges
Select the Scanner as the Input Device
1
Touch once the desired part of the screen.
The media selection screen is displayed.
2
Touch [FILM].
Note
The following buttons are available for this screen
and the screens that follow. Touch the buttons
when required.
• If you touch the [Start Over] button, a message
prompts you to confirm that you want to
completely cancel the current operation. If you
touch the [OK] button, the display returns to the
screen in Step 1 of "Select the Scanner as the
Input Device".
• [Return]. Touch to return to the previous screen.
• [Help]. Touch to display online Help for a
description of procedures applicable to the
current screen.
19