Sony UPA-PC100 Benutzerhandbücher Seite 38

Changing the Settings
• [IX240] button (not available with [FlatbedScanner]
selected)
When scanning APS (IX240) film, you can select the
resolution: [SD-W] (831 dpi) or [HD-W] (1663 dpi).
Touch the [35 mm] button to open the screen, select
the resolution setting, then touch the [OK] button.
[Terminal] button
Touch this button to open the [Setting - H/W -
Terminal] screen.
Use these settings to enable or disable the slot or drive
on the main unit. Touching one of the buttons selects
[ON] (for enabled) or [OFF] (for disbled).
SETTING END
• Touch the [OK] button to temporarily save the
settings selected on the screen and return to the
Configuration Utility's initial [Setting] screen. To
save the settings and close the [Setting] screen, touch
the [OK] button.
• Touch the [Cancel] button to cancel the settings you
have made, restore the previous settings, and return to
the initial Configuration Utility [Setting] screen.
38
[Setting - Menu] Screen
Touch the [Menu] button to open the [Setting - Menu]
screen that presents various options for output
services.
[Print] button
Touch this button to open the [Setting - Menu - Print]
screen and make the settings for the [Prints] output
service.
• [ON/OFF] button
When this setting is [ON], you can select [Prints] as
the output service at the output service selection
screen. Touch this button to toggle the setting [ON]
(service enabled) or [OFF] (service disabled).
• [Size] button
Selects the paper size for [Prints] output. Touch this
button to open the paper size selection screen, touch
[3.5 × 5], [4 × 6], [5 × 7], or [8 × 10] to select the
paper size, then touch the [OK] button.