Hürner HST 300 Print+ 2.0 Bedienungsanleitung Seite 35

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
8.2 Downloading All Reports
After the file type was selected, the next screen offers a "Print All Re-
ports" option. Selecting it will download all welding reports currently
in system memory in the previously selected file format.
8.3 Downloading by Commission Number, Date or Report
Range
After the file type was selected, the next screen offers a "By Commis-
sion Number," a "By Date Range," and a "By Report Range" options.
Depending on the selection, the ñ and ò arrow keys can be used to
select from the commissions currently in system memory the desired
one, of which the reports should be downloaded, or the alphanumeric
keypad can be used (see Info in Sect. 5.2) to enter a start date and an
end date, or the first and the last report, that define a range of dates
or a range of reports of which the reports should be downloaded.
When you press the START/SET key, you cause the selected reports to
be transferred to the storage media.
8.4 Understanding the Report Download Process
The download starts automatically after a selection was made among
the options. Wait for all the selected reports to transfer and the
"Download completed" message to appear on the screen.
If a problem occurs while the download is in progress, a "Not ready"
message shows. After the problem condition is cleared, the download
resumes automatically.
If the welding unit recognizes a problem that cannot be
cleared while the data transfer is in progress, it does not
Info resume the process and displays a "Download cancelled"
error message. To acknowledge this error, press the START/
SET key.
8.5 Deleting Data from Memory
The report data in memory can be deleted only after all welding reports
were transferred, which is indicated by the "Download completed"
message. When the storage media is unplugged, a "Delete Memory"
message appears. If the START/SET key is pressed at this point, a fur-
ther confirmation message "Delete Memory, sure?" is shown, which
has to be confirmed by pressing the START/SET key once again. Then,
the report data in memory are deleted.
8.6 Keeping Data in Memory
When the cable or storage media is unplugged, a "Delete Memory"
message is displayed. Press the STOP/RESET key to keep the current
report data in memory. They can then be printed off once again.
Make a habit of handling the internal storage as described
at the beginning of Sect. 8, to maintain data integrity and
avoid any inadvertent deletion of the reports in memory.
Important
9 Dedicated Welding Unit Information
9.1 Displaying Characteristics of the Welding Unit
The key technical information on the welding unit itself is displayed
by pressing the ð key at the "Enter Fitting Code" screen. They are
Version August 2014 HÜRNER HST 300 Print + 2.0 User's Manual
15
EN