Hürner HST 300 Print+ 2.0 Bedienungsanleitung Seite 33

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
6.7 Recording the Geo-data of the Planned Joint
This section applies only to the product version with GPS
module.
Provided that geo-data recording is enabled in the configuration menu
(see Sect. 10.2), the geographic coordinates can be recorded, if the
GPS module is on, as soon as Display 12 shows on the screen.
Wait at least 1 minute from switching the GPS module on to
the actual recording of the geo-data, or the GPS module will
throw a not-ready error.
Important
During the first minute after switching the GPS module on the follow-
ing messages may appear on the screen: "No signal," "GPS module
failed," "GPS Error, Restarting," and "GPS Module not Ready." These
are no errors during the starting minute of initialization right after
switching on. If they appear after this time, they have to be consid-
ered actual error messages. In this case, the restart after a GPS (signal
processing) error will be performed by the module itself, without any
user action. The Not Ready message disappears automatically, too, as
soon as the module is ready for recording.
The geo-data are recorded after you selected "Yes" in Display 12 using
the ñ and ò arrow keys and confirmed this selection by pressing the
START/SET key. A message confirms that the data have been recorded.
The recorded data then show on the screen (see Display 13). A second
screen is used to display additional information on the precision at the
time of recording. To switch back and forth between both geo-data
screens, press the ð key.
If it is likely that no satisfactorily precise position will be recorded be-
cause of relatively poor signal strength, a warning message tells you,
after you pressed the START/SET key in Display 12, "Poor GPS signal;
record data?". When this message is showing, you can still start re-
cording the position by pressing the START/SET key or go on without
recording by pressing the STOP/RESET key.
The recorded position is the one the GPS module is at at the
moment of recording. This means that in situations where
the welding unit cannot be set next to the joint that is being
welded, it is possible to start by placing the welder/the GPS
Info
module next to the future joint, then to record the geo-data,
and finally to move the welder to the place where it will be
during the welding process.
7 Entering Welding Parameters Manually
To be able to enter the welding parameters manually, you have first
to connect the fitting to the welding unit with the welding cable.
The manual input of the parameters can then be accessed by pressing
the ò arrow key. The screen will show a menu as reproduced in Dis-
play 14, provided manual input is enabled in the configuration menu
(see Sect. 10.1). In other words, the manual parameter input replaces
reading the bar code of the fitting with a scanner.
Using the arrow keys ñ and ò you can select "Enter Voltage/Time" or
"Enter Fitting Code" (i.e., the numbers that represents the code of
the fitting to be used). Confirm your selection by pressing the START/
SET key.
Version August 2014 HÜRNER HST 300 Print + 2.0 User's Manual
Record Geo-Data
>Yes
No
Display 12
Current Position
050·38,4873'N
008·59,4141'E
Sat:7
Display 13
** MANUAL INPUT **
>Enter Voltage/Time
Enter Fitting Code
Display 14
EN
13