Hürner HST 300 Print+ 2.0 Bedienungsanleitung Seite 32

job number will be saved to memory and will appear in the printed
welding report.
Provided is was enabled in the configuration menu (see Sect. 10.2), a
commission number-related joint number is also recorded and shown
along with the report number (see Sect. 5.3). To say that the joint
number is related to the job, or commission, number means that the
system checks, when a commission number was entered, whether
it exists already in the internal memory. If so, it takes the highest
existing joint number for that commission, increments it by 1, and
applies this new joint number to the next welding operation in that
commission.
6.3 Entering or Changing Additional Data
The additional data input screen is shown by the unit before welding,
first the screen that allows entering the first additional data, then the
one for the second additional data. This input can be entered either
using the alphanumeric keypad (see Info in Sect. 5.2) or by reading
from a bar code using the scanner.
For the first additional data input, the maximum length is 20 charac-
ters. For the second data input, the maximum length is 15 characters.
Confirm your input by pressing START/SET. The additional data will be
saved to memory and appear in the welding report. By pressing STOP/
RESET, you skip this screen without any input.
You are free to define any additional data you see fit. For
instance, you can put into these fields information on pipe
length, ditch depth, or comments that help with welded joint
Info traceability.
6.4 Entering the Fitting Traceability Code
If this feature is enabled in the configuration menu, after the fitting
code was entered, another input "Fitting Code" is required. This is the
so-called "traceability code" or "second fitting code" of the fitting.
This input is entered either from a bar code using the scanner or
manually using the alphanumeric keypad (see Info in Sect. 5.2). Press
the START/SET key to confirm your input. If the code entered is not
correct, a "Code Error" message appears; check the string of numbers
and correct as needed. If the code entered is correct, it is saved to
system memory and inserted into the welding reports to be printed.
By pressing the STOP/RESET key, you skip this input.
6.5 Entering Weather Conditions
If the weather conditions feature is enabled in the system set-up, this
input is required before the fitting code can be entered.
Use the arrow keys ñ, ò to select from "sunny," "dry," "rain," "wind,"
"tent," and "heating." Press the START/SET key to confirm your selec-
tion. The selection is saved to memory and will appear in the printed
welding report.
6.6 Entering Data on the Jointed Components
According to the same procedure as used for entering the fitting
traceability code (see Sect. 6.4), prior to the welding proper the ISO-
compliant codes of the pipes to be welded, their length as well as
the installing company can be entered for inclusion in the welding
reports. For this to be possible, they have to have been enabled in
the configuration menu.
12
EN
HÜRNER HST 300 Print + 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
** Addit'l Data 1 **
********************
*** Fitting Code ***
********************
******
**** WEATHER
>sunny
dry
rain
Version August 2014
Display 9
Display 10
****
Display 11