Hürner HST 300 Print+ 2.0 Bedienungsanleitung Seite 28

All data that are relevant for the weld or for traceability are saved to
the internal memory and can be sent to a USB stick.
Welding data transfer is enabled through an interface of the USB A
type, which is compatible with a USB stick.
Further Optional Accessories
• PC software for downloading and archiving data on PC (for all
common Windows operating systems)
• Label tag printer for printing an identifier label for the new
joint right after the welding operation
• USB stick for data transfer from the welding unit on the worksite
to the printer or PC in your office (see details at the end of this
booklet)
5 Check-out and Operation
• To operate the welding unit, be sure that it is set on a proper,
level surface.
• Be sure that power supply/generator protection is 16 A (slow
blow).
• Plug the power supply cord into the mains power supply or the
generator.
• Read and comply with the User's Manual of the generator, if ap-
plicable.
5.1 Turning the Welding Unit on
After connecting the power supply cable to mains power or a gen-
erator, turn the welding unit on using the On/Off switch. This causes
Display 1 to show.
Then the screen changes to Display 2.
CAUTION in case of System Errors!
If during the auto-test that the unit performs at start-up, an
error is detected, a "System Error" message shows on the
display. When this happens, the welding unit has to be discon-
Caution
nected immediately from the power suppy and the fitting,
and it has to be shipped to the manufacturer for repair.
5.2 Entering the Welder ID Code
The alphanumeric keypad is designed and works like the
keypad of a common mobile phone without touch screen
display. All characters found on a key can be "browsed" by
pressing that key repeatedly at short intervals. As soon as
Info
"browsing" generates the desired character on the screen,
wait a little longer until you press the next key to use the
displayed character. The first character always is the number
on the respective key, then the letters or marks in the order
on the key, i. e., for instance, with the key "2 | a | b | c" the
1 keypress brings up "2," the 2
st
4 brings up "c." By default, lower-case letters appear on
th
the screen. To enter upper-case letters, hold down the ñ
key while selecting the appropriate letter by one or several
keypresses.
The welding unit can be configured to ask for the welder identification
code before the fitting code is entered. The display screen then shows
the message "Enter Welder Code." (Later this screen can be accessed
8
EN
"a," the 3
nd rd
HÜRNER HST 300 Print + 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
********************
HST 300 Print+ 2.0
********************
Enter Fitting Code
14:32:11
Inp.Volt. 230V
No Contact
"b," and the
***
********************
Nieder-Ohmener Str. 26
35325 Mücke, Germany
HUERNER
Display 1
21.10.12
50Hz
Display 2
Welder Code ***
Display 3
Version August 2014