Spare Parts; Disposal; Information On The Collection Of Used Electrical And Elec- Tronic Products - Wilo RAIN3 Einbau- Und Betriebsanleitung

Incident
Break tank overflow
Cistern overflow
Cistern high water alarm
Maximum pump cycles per
hour
Max. runtime pump
11

Spare parts

12

Disposal

12.1 Information on the collection of
used electrical and electronic
products
Installation and operating instructions • RAIN3 • Ed.04/2023-10
Error code Cause
Signal value above 20 mA
due to fact system pressure
is exceeded
E66.0 Sensor for overflow signals
a fill level in the replenish-
ment reservoir that is too
high
E66.1 Over flow on threshold
cistern (5.51) exceeded
E66.2 High water on threshold
cistern (5.24) exceeded
E140 Frequent starts due to
leakage (number of starts in
a certain time period)
E141 Max. continuous operation
time reached, leakage in
system
If the fault persists or cannot be rectified, contact qualified personnel or Wilo customer ser-
vice.
Spare parts are ordered via customer service. To avoid return queries and incorrect orders,
the serial or article number must always be supplied (see rating plate).
Subject to change without prior notice!
Proper disposal and appropriate recycling of this product prevents damage to the environ-
ment and danger to your personal health.
Please note the following points to ensure proper handling, recycling and disposal of the
used products in question:
• Hand over these products at designated, certified collection points only.
• Observe the locally applicable regulations!
Please consult your local municipality, the nearest waste disposal site, or the dealer who
sold the product to you for information on proper disposal. See www.wilo‑recycling.com
for more information about recycling.
Self-acknow-
ledging
NOTICE
Disposal in domestic waste is prohibited!
In the European Union this symbol may be included on the product, the
packaging or the accompanying documentation. It means that the elec-
trical and electronic products in question must not be disposed of along
with domestic waste.
Next steps
Pump switches off.
The cause (pressure increase due to heat-
ing or impermissible inlet pressure) must
be recognised, the system pressure must
have dropped below the value of the per-
missible rated pressure ("5.17") and ac-
knowledged.
Forced switchover to drinking water mode
(TWM), an error is generated.
Check replenishment valve.
Only for information and as a counter in
the history.
Rainwater storage tank overflow is de-
sired.
Pump switches off, an error is generated,
switch to drinking water mode.
Check for possible contamination in the
rainwater storage tank.
The error must be consciously acknow-
ledged (from access level 2).
An error is generated.
Pump switches off, an error is generated.
en
63