Service, Repair; Decommissioning, Disposal; Appendix - MICRO-EPSILON induSENSOR MSC 7210 Betriebsanleitung

Service, Repair

8.
In the event of a defect on the sensor or the sensor cable:
- If possible, save the current sensor settings in a parameter set, in order to load again the settings back
- Please send us the affected parts for repair or exchange.
In the case of faults the cause of which is not clearly identifiable, the entire measuring system must be sent
back to:
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Str. 15
94496 Ortenburg / Germany
9.
The induSENSOR MSC 7210 series is produced according to the directive 2011/65/EU („RoHS").
10.
Optional Accessory
C7210-5/3
C7210/90-5/3
PC710-6/4
induSENSOR MSC 7210
All manuals and user guides at all-guides.com
Service, Repair
into the sensor after the repair.

Decommissioning, Disposal

Disconnect the sensor cable, power supply and output cable on the controller.
Do the disposal according to the legal regulations (see directive 2002/96/EC).

Appendix

3-pin sensor cable with female cable connector and tinned leads, length 5 m
3-pin sensor cable with 90 ° elbow jack (on sensor side) and tinned leads, length 5 m
4-pin power supply and output cable with tinned leads, length 6 m
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
info@micro-epsilon.de
www.micro-epsilon.com
Page 53