TOOLCRAFT TPS-800 Bedienungsanleitung Seite 59

13. Error messages on the display
Error code, error type
Error "E0", problem with fan
Error "E1", functional problem with
the heating element
Error "E2", faulty sensor contact
Error "E3", abnormal mains voltage
zero crossing sensor
Error "E5", overcurrent/short circuit
in the heating element
Error "E7", short circuit in tempera-
ture sensor
Error "E8", excessive temperature
Error "E9", incorrect/abnormal hot
air nozzle
58
Description
The fan is not working, the fan sensor is faulty, or there is a bad contact.
Ask a technician to inspect the product.
The heating element or corresponding sensor is faulty. Replace the entire
hot air nozzle (including hose/connector) with a new unit or ask a techni-
cian to inspect the product.
There is a bad contact between the hot air nozzle and workstation. Discon-
nect and then reconnect the connector between the hot air nozzle and
workstation. If the issue persists, ask a technician to inspect the product.
The frequency of the mains voltage is outside of the operating parameters
(see "Technical Data") or the product is powered by an electricity generator
and not via the public grid.
If this is not the case, ask a technician to inspect the product.
The heating element is faulty (short circuit). Replace the entire hot air
nozzle (including hose/connector) with a new unit or ask a technician to
inspect the product.
The temperature sensor in the hot air nozzle has a short circuit. Replace
the entire hot air nozzle (including hose/connector) with a new unit or ask a
technician to inspect the product.
Turn the product off and let it cool down completely before using it again.
Do not squeeze/pinch or place any objects on the air hose!
The temperature sensor in the hot air nozzle may have a short circuit.
Replace the entire hot air nozzle (including hose/connector) with a new unit
or ask a technician to inspect the product.
The hot air nozzle does not fit into the work station. Only use original
replacement parts.
The internal electronic components are defective. Ask a technician to
inspect the product.