Werbung
Verfügbare Sprachen
Verfügbare Sprachen
"UI Mode"
1
Use this option to select the workstation mode.
In the normal operating mode ("Normal"), the hot air is controlled based on the temperature and air flow settings (see
display in section 9c).
In profile mode ("Profile"), the workstation uses a programmable time/temperature profile (a temperature curve with
a corresponding air flow).
After you switch to profile mode, other menu options are displayed for the functions/profile menu.
"Edit Profile"
2
Press the "MENU/ENTER" button after selecting this menu option.
Use the "
"/"
" button to select the profile memory that you
wish to configure/change (there are 25 profile memories in total).
If the profile contains data, the corresponding profile curve will be
displayed.
The first 3 profiles are configured by the manufacturer, but
can be deleted or changed as desired.
The settings from the first 3 profiles will be deleted if the
workstation is restored to factory settings.
Press the "MENU/ENTER" button to confirm the selected profile
memory.
If the profile is empty, the settings can be configured one after an-
other. If the profile already contains data, the settings can be changed
or new settings can be added.
Use the "
" or "
to change or enter. Press the "MENU/ENTER" button to change the
corresponding values. Press the "MENU/START" button to confirm
the new setting. The programmable value will be highlighted in white
on the display.
The following settings can be configured:
• "Step"
Each profile can consist of up to 9 different steps (the profile in the
right-hand image has 5 different steps).
A new step can only be added after the most recently selected step.
• "Time"
Use this option to configure the duration of the current step in the profile. The maximum total duration of the profile
is 600 seconds.
The most recently selected step can be deleted by entering a time of "0" seconds.
54
" buttons to select the setting that you want
Werbung
