TOOLCRAFT TPS-800 Bedienungsanleitung Seite 56

• "Temp."
Use this option to configure the desired target temperature for each of the steps.
• "Air"
Use this option to configure the desired air flow for each of the steps.
• ""Exit"
After you select "Exit" you will be prompted to save the profile. Confirm the desired selection with the corresponding
arrow button (" " = cancel, "
"Copy Profile"
3
Use this option to copy an existing profile, e.g in order to create several similar profiles. This saves time, because you
don't need to enter the complete profile again.
Press the "MENU/ENTER" button after selecting this menu option.
Use the " "/" " buttons to select the "Source" and "Dest." (des-
tination).
• "Source" = profile that you want to copy
• "Dest." = profile that you want to overwrite
Press the "MENU/ENTER" button, and then use the "
" buttons to enter the number of the profile.
If the memory slot already contains a profile, the profile will be dis-
played on the left-hand side of the display.
After you select "Exit", you will be prompted to copy the profile. Confirm the desired selection with the corresponding
arrow button (" " = cancel, "
"Delete Profile"
4
Use this option to delete profiles that you no longer require.
Press the "MENU/ENTER" button after selecting this menu option.
Use the " " or "
delete (there are 25 profiles in total). The curve for the selected profile
will be shown on the left-hand side of the display.
Press the button "MENU/ENTER" button. A prompt will be displayed
asking whether you wish to delete the profile. Confirm the desired
selection with the corresponding arrow button ("
" " = delete).
"Exit"
5
Use this menu option to exit the profile menu (alternatively, wait a few seconds without pressing any buttons).
" = save).
" = copy).
" buttons to select the profile that you want to
" and "
" = cancel,
55