TOOLCRAFT TPS-800 Bedienungsanleitung Seite 43

• Insert the vacuum suction lifter into the corresponding socket (6). This may
require a little effort, as the seal must be secure.
If the thin suction hose gets in the way when the suction lifter is being con-
nected, it can be carefully removed.
• Insert the holder into the hole (10) on the right side of the workstation.
• Use the spiral cable provided to connect the jack socket in the holder to the
corresponding socket (15) on the back of the workstation.
The holder contains a switch contact. When the hot air nozzle is cor-
rectly placed in the holder (e.g. during a break), the heating function
and the fan will be switched off automatically. In addition to acting as a
safety feature, this also helps to reduce energy consumption.
• Place the hot air nozzle in the holder. The switch on the hot air nozzle should
be pointing upwards.
• The metal stand can be placed underneath the workstation. The slide-out
drawer is divided into several compartments, which you can use to store the
supplied accessories.
• Switch off the workstation (move the on/off switch to the "0" position).
• Use the mains cable provided to connect the workstation to a standard earthed
mains socket which is connected to the public grid (wall-mounted socket)
• Turn on the workstation (move the on/off switch to the "I" position). The display
will turn on and show a welcome message for a few seconds before switching
to the normal display.
42