TOOLCRAFT TPS-800 Bedienungsanleitung Seite 50

c) Function menu settings
The system menu is initially displayed when you access the menu. Briefly press button "3" to switch to the functions
menu; use button "2" to revert to the system menu.
Use the " " or "
Briefly press the "MENU/ENTER" button to access the selected option, and then use the "
change the setting. Briefly press the "MENU/ENTER" button to exit the setting.
If no button is pressed for several seconds, the settings will be saved and the display will automatically exit the system/
functions menu.
The following menu options are available:
1
English Function
UI Mode Switch modes (temperature/air flow or profile mode)
Temp Offset Set the temperature offset to calibrate the hot air temperature
Timing Work Set a timer after which the hot air is automatically switched off (press the button on the hot air
nozzle to start the timer)
Shortcut Temp1 Preset temperature for quick selection button "1"
Shortcut Air1 Preset air flow for quick selection button "1"
Shortcut Temp 2 Preset temperature for quick selection button "2"
Shortcut Air 2 Preset air flow for quick selection button "2"
Shortcut Temp 3 Preset temperature for quick selection button "3"
Shortcut Air 3 Preset air flow for quick selection button "3"
Temp Upper Set the upper temperature limit
Temp Lower Set the lower temperature limit
Temp Lock Switch temperature lock on/off
Exit Exit the menu
"UI Mode"
2
Use this option to select the workstation mode.
In the normal operating mode ("Normal"), the hot air is controlled based on the temperature and air flow settings (see
display in section 9c).
In profile mode ("Profile"), the workstation uses a programmable time/temperature profile (a temperature curve with
a corresponding air flow).
After you switch modes, other menu options will be displayed. A description of these new menu options and
profile mode is provided in section 11.
" buttons to select the desired menu option (see following table).
" or " " buttons to
49