Ossur i-LIMB HAND Gebrauchsanweisung Seite 8

– When turned off: the display will fully light up and then switch off.
Checking the Battery Charge Level Status
– The battery charge level is shown by the bars when the power is on.
– Each bar of light shows a 20% charge level. The number of bars lit up shows how much power is left in the
battery.
– When the battery level reaches 5%, the red low battery warning will light up (Fig. 13). The light will shine for
3 minutes, and then the device will turn itself off.
NOTE: an emergency reserve of power remains available, to turn on and release the device from an object,
ensuring the safety of the user.
Charging the Battery
WARNING: Do not wear an i-Limb hand when the battery is charging.
– Plug the mains charger into the power outlet. Attach the magnetic charger to the charger port on the
prosthesis.
– When in standby, the charger unit will display a faint green light.
– When charging is in progress, a red light is displayed.
– When fully charged a green light is displayed.
– Charging time: 90 minutes to 3 hours.
– A car charger is also available.
External Battery
If the i-Limb has external batteries, remove the batteries from the prosthesis and insert into the charger base unit
(Fig. 14). Connect the charger base unit with the power cable. Plug the power cable into the power outlet.
The charging state is indicated on the back of the base unit:
– Middle light on: charger is plugged in
– 2nd and 5th lights flashing green: batteries are charging
– 2nd and 5th lights solid green: batteries are charged
– 1st and 4th red lights on: battery fault, unplug and try again. If lights continue to illuminate, contact your clinician.
Power Supply
CAUTION: Only use the Össur power supply to charge Össur batteries.
Manufacturer:
Model No.:
Input:
Output:
CONTROLLING THE I LIMB HAND
Identifying the Device Number:
The device number can be found proximal to the thumb base (Fig. 15). For extra small hands, or those with
a flexion wrist, the number is located within the chassis.
When connecting your i-Limb hand with the My i-Limb app, the device number will be displayed on the connection
screen. Selecting the number connects the app to your i-Limb hand. Alternatively, when connected to the app your
device number is displayed in the 'about' section.
PowerSolve
000311A
100-240Vac, 50-60 Hz, 0.3A Max
8.4VDC, 1A
8