PeakTech 1215 Bedienungsanleitung Seite 82

4. How to Carry on the Function Inspection
Make a fast function check to verify the normal operation of the instrument, according to the following
steps:
1. Connect the Instrument to the Power and Push down the Power Switch Button.
The instrument carries out all self-check items and shows the prompt "Press any Key Enter the Operating
Mode". Press the "UTILITY" button to get access to the "FUNCTION" menu and push down F2 the menu
selection button to call out the function "Recall Factory". The default attenuation coefficient set value of
the probe in the menu is 10X, shown as Fig. 4.
2. Set the Switch in the Oscilloscope Probe as 10X and Connect the Oscilloscope with CH1
Channel.
Align the slot in the probe with the plug in the CH1 connector BNC, and then tighten the probe with
rotating it to the right side.
Connect the probe tip and the ground clamp to the connector of the probe compensator, shown as Fig. 5.
Fig. 4 Power on the Instrument
81