PeakTech 1215 Bedienungsanleitung Seite 143

37. Appendix A: Technical Specifications
Unless otherwise specified, the technical specifications applied are applicable to the probe with the
attenuation switch setting 10X and the PeakTech
following two conditions at first, can these specification standards be reached.
•
This instrument should run for more than 30 minutes continuously under the specified operating
temperature.
•
If the change range of the operating temperature is up to or exceeds 5°C, open the system function menu
and execute the "Auto-calibration" procedure.
All specification standards can be fulfilled, except one(s) marked with the word "Typical".
Sampling
ACQU Mode
Sampling Rate
Input
Input Coupling
Input Impedance
Probe attenuation coefficient
Max. Input Voltage
Horizontal System
Sampling Rate Range
Waveform interpolation
Record Length
Scanning Speed Range (S/div )
Measuring Accuracy of Time Interval
(△T) 60 MHz
Sample rate/ relay time accuracy
®
digital oscilloscope. Only if the oscilloscope fulfill the
Sample
Peak Detection
Average
500 MS/s for each channel
DC, AC, Ground
1MΩ± 2%, connected with 15pF± 5pF in parallel
1X, 10X, 100X, 1000X
400V (DC+AC
pp
1S/s ～ 500MS/s
(sinx) /x
5000 sampling points per channel
5ns/div～5s/div, according to the stepping mode of 1- 2.5- 5.
Single: ± (1 Sampling Interval Time +100ppm × Reading
+0.6ns)
>Averages of 16: ± (1 Sampling Interval Time +100ppm×
Reading +0.4ns)
± 100 pp
142
)
pp