PeakTech 1215 Bedienungsanleitung Seite 80

1. The Trigger State indicates the following information:
Auto: The oscilloscope is under the Automatic mode and is collecting the waveform under the non-trigger
state.
Trig' d: The oscilloscope has already detected a trigger signal and is collecting the after-triggering
information.
Ready: All pre-triggered data have been captured and the oscilloscope has been already ready for
accepting a trigger.
Scan: The oscilloscope captures and displays the waveform data continuously in the scan mode.
Stop: The oscilloscope has already stopped the waveform data acquisition.
2. Waveform Viewing Area.
3. The purple pointer indicates the horizontal trigger position, which can be adjusted by the horizontal
position control knob.
4. The reading shows the time deviation between the horizontal trigger position and the screen centre line,
which equals 0 in the screen center.
5. This reading shows the time deviation between the horizontal trigger position and the window centre line,
which is regarded as 0 in the window center.
6. It indicates the current function menu.
llustrative Drawing of Display Interfaces
Fig.3 Illustrative Drawing of Display Interfaces
Fig. 3 Illustrative Drawing of Display Interfaces
79