PeakTech 1215 Bedienungsanleitung Seite 125

33. Measure
Four automatic measured values can be shown one time at maximum for the wave form of each channel. Only
if the wave form channel is in the ON state can the measurement be carried out. No automatic measurement
can be made for the saved or the mathematically manipulated wave form, or in the XY or Scan format.
Measure the frequency, the peak-to-peak value of the Channel CH1 and the mean, the RMS of the Channel
CH2, according the following steps:
1. Press the F1 menu selection button and choose Source.
2. Press the F2 menu selection button and choose CH1.
3. Press the F3 menu selection button and choose CH1.
4. Press the F4 menu selection button and choose CH2.
5. Press the F5 menu selection button and choose CH2.
6. Press the F1 menu selection button and choose Type.
7. Press the F2 menu selection button and choose Freq.
8. Press the F3 menu selection button and choose Pk-Pk.
9. Press the F4 menu selection button and choose Mean.
10. Press the F5 menu selection button and choose Cyc RMS.
The measured value will be displayed in the reading window automatically (see Fig. 50).
Fig. 50 Automatic Measurement
124