Electrical Safety - Parkside PMRDA 20-Li A1 Originalbetriebsanleitung

GB MT
• Replace worn or damaged parts
in the interests of safety. When
setting up the blades, take care
that your fi ngers do not become
caught between the rotating
blades and stationary parts of
the machine.
• Ensure that only replacement
cutting tools approved by the
manufacturer are used.

Electrical safety:

• Make sure that the mains volt-
age matches the details on the
type plate.
• Avoid body contact with
earthed parts (e.g. metal fences,
metal posts).
• Keep the power cord away from
the cutting tool when working.
The cutting blades can damage
the power cord and lead to con-
tact with live parts.
• Do not use the power cord to
pull the plug from the outlet. Pro-
tect the power cord from heat,
oil and sharp edges.
• Switch the device off and pull
the mains plug out of the outlet
if the power cord is damaged.
If the cord of this device is dam-
aged, it must be replaced by the
manufacturer or their customer
service or by a similarly qual-
ifi ed person in order to avoid
hazards.
50
• Do not connect a damaged
power cord to the power sup-
ply. Do not touch a damaged
power cord as long as it is con-
nected to the power supply. A
damaged power cord can result
in voltage-carrying parts being
touched.
• Only connect the machine and/
or its peripherals to supply cir-
cuits protected by a residual cur-
rent device with a rated residual
current of no more than 30 mA.
Special safety instructions for
battery-powered devices:
• Ensure that the device is
switched off before inserting the
rechargeable battery. Inserting
a battery into a power tool that
is switched on can lead to acci-
dents.
• Only charge your batteries in-
doors since the charger is not
designed for outdoor use. Dan-
ger of electric shock.
• In order to minimise the risk of
electric shock, pull the charger
plug out of the outlet prior to
cleaning it.
• Do not expose the battery to
direct sunlight for long periods
and do not place it on a radia-
tor. Heat damages the battery
and there is a risk of explosion.
• If warm, allow the battery to
cool before charging.