Electrical Safety - Parkside PRM 1800 A1 Originalbetriebsanleitung

• Replace worn or damaged
parts for safety reasons. Use
only original spare parts and
accessories.
• Allow the motor to cool down
before you put the machine into
storage. Risk of burns!

Electrical Safety:

• Ensure that the mains voltage
matches the speciications on
the rating plate.
• Connect the equipment only
to a socket that has a residual
current operated device (RCD
switch) with a trip current of no
more than 30 mA.
• Avoid bodily contact with
earthed parts (e.g. metal
fences, metal posts). There is an
increased risk of electric shock
if your body is earthed.
• Use only authorised power cables
of H05RN-F, which are no more
than 75 m long and suitable for
outdoor use. The power cable
wire cross section must be at least
2.5 mm . Always completely
2
unroll cable drums before use.
Check the cable for damage.
• To ix on the power cable, use
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when work-
ing. The cutting blades may
damage the power cable and
result in contact with live parts.
Always run the power cable be-
hind the operator.
The extension cable can be
accidentally severed. Risk of
electric shock!
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.
• Switch off the equipment and
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
by the manufacturer, the cus-
tomer services of the same, or
a qualiied person, in order to
avoid hazards.
• Do not connect a damaged
power cable to the mains. Do not
touch a damaged power cable
when it is connected to the mains.
A damaged power cable may
result in contact with live parts.
Residual risks
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this electric
tool may present the following hazards:
a) Injuries caused by moving parts;
b) Ear damage if working without ear pro-
tection;
c) Lung damage, if suitable respiratory
protection is not worn;
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this elec-
tric tool generates an electromagnetic
ield which, under certain circum-
stances, may impair the functionality
of active or passive medical implants.
To reduce the risk of serious or lethal
GB
MT
29