Activating Bluetooth; Features Of The App; Secondary Areas - Parkside PMRDA 20-Li A1 Originalbetriebsanleitung

The app now searches for available
devices and suggests them to you.
13. Select the desired device by pressing
the to add it to the app.
14. First confi rm with "Next", then with
"Finish".
Upgrading the fi rmware can change
the features of the app.

Activating Bluetooth

Bluetooth is only required to connect
®
the device with the Lidl Home App.
After the device is connected to the Lidl
Home app, the Bluetooth
only switches on again when the device is
reset to factory settings.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Confi rm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select "Ac-
tivate WiFi".
7. Confi rm the selection with the OK but-
ton (7).
This is required for the initial connec-
tion with the Lidl Home App, after
which there is a WLAN connection and the
Bluetooth function of the mower is inac-
®
tive.

Features of the app

If you select a lawn mower, this will take
you to the overview page.
®
switches off and
®
Press the button in the left circle and hold
your thumb on the display to swipe the
"START " selection up and down.
To select the individual menus via the
"START " position.
Schedule
Here you can set two operating periods for
the lawn mower for each day of the week.
The lawn mower must be in standby mode
so that you can make settings here.
1. Select the desired day.
2. For the period defi ne a start time and
an end time.
3. Save the schedule at the top right at
"Save".
The schedule can be reset in the practise
menu on the right via "Reset".

Secondary areas

Here you can set up to 5 secondary areas.
The lawn mower must be in standby mode
so that you can make settings here.
1. Select a secondary area.
2. Set the distance to the entry point.
The lawn mower travels along the
boundary wire for the distance
you have specifi ed and then starts mow-
ing.
3. Set a percentage of area.
The area percentage indicates
what percentage of the total area
within the boundary wire is to be
mown.
The sum of the area percentages of the
5 secondary areas must be less than/
equal to 100 %.
4. Confi rm with "Save".
If you do not want to divide the area
to be mown into secondary areas,
select:
Distance to the entry point: 1 m
Percentage of area: 100 %
GB MT
69