Electrical Safety; Assembling Instructions; Assembling The Curved Handle - Parkside PRMA 20-Li A1 Originalbetriebsanleitung

• Check that only replacement
tools authorised by the manu-
facturer are used.

Electrical Safety:

• The plug of the charger must fi t
into the socket. The plug must
not be modifi ed in any way.
Do not use any adapter plugs
together with electric tools that
have a protective earth. Unmodi-
fi ed plugs and matching sockets
reduce the risk of electric shock.
• Avoid body contact with
earthed surfaces such as pipes,
radiators, cookers and refriger-
ators. There is an increased risk
of electric shock if your body is
earthed.
• Do not expose electric tools to
rain or wet conditions. The pen-
etration of water into an electric
tool increases the risk of electric
shock.
• Do not use any accessories that
are not recommended by PARK-
SIDE. This can result in electric
shock or fi re
Observe the safety in-
formation and notes on
charging and proper
use as shown in the
instruction manual for
your battery and char-
ger from the Parkside
X 20 V Team series. A
detailed description of
the charging process
and further informati-
on can be found in the
separate operating inst-
ructions.

Assembling instructions

• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confi dent.
• In case of uncertainty, contact a spe-
cialist or contact our service directly
Assembling the
Curved Handle
Installing lower bars:
1. Slide the two ends of the lower
handle bar (3) into the receptor
on the mower housing.
2. Fix the lower bar by means of
the tensioning levers (2a).
3. Lock the clamping levers (2a) by
pushing them towards the bar (1).
Clamping levers to be tightened
and contacting the bar such that
they clamp at average force.
Otherwise you may have to
tighten (turn clockwise) or loosen
them (turn anticlockwise).
There are two positions possible.
Installing upper handle:
4. Attach the bow-type handle (1)
to the lower bars (3) with the en-
closed wing nuts (2b) and quick
release levers (2a).
Mounting cable holder:
5. Clip the cable holder (
into the bar (3) and thus fi x the
cable (
A
If you release the quick release
levers (2a), you can fold the bow-
type handle (1) downwards to store
the device. Ensure that the power
cable (
A
A
14)
13).
13) is not caught.
GB
11