Spot Mode / Fi Xed Point Mowing - Parkside PMRDA 20-Li A1 Originalbetriebsanleitung

GB MT
Motor error
EM sensor not
connected
Hall sensor failure
Hardware error
Charge abnormal
Discharge abnormal
Battery discharge error
Inertial measurement
unit (IMU) error
Motor error
Motor switched off
Motor Hall sensor error
Motor overcurrent
Motor blocked
Motor standstill right
Rain sensor failure
Loop sensor failure
Spot mode / fi xed point
mowing
This function allows you to mow lawns that
are otherwise covered by seating furniture,
playground equipment or similar.
1. Place the mower on the target area of
the lawn.
2. If necessary, open the cover (1).
3. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
4. Press the OK button (7) to enter the
main menu.
5. Select "Spot mode" with the arrow but-
tons (6).
The display shows "Close the cover to
start".
6. Close the cover (1) and the mower
starts mowing with the fi xed point.
62
Contact manufacturer (see "Service Centre")
The lawn mower mows in an anti-
clockwise spiral direction and
switches to "Automatic mowing" after a
mowing radius of 1 m or 3.5 minutes of
mowing.
If the mower encounters an obstacle, the
mower stops, the display indicates that
mowing has stopped and the mower
switches to standby mode.
When the lawn mower hits the boundary
wire (11), it continues mowing in the oppo-
site spiral direction.
If the mower is outside the bounda-
ry wire (11) or on the charging sta-
tion and you select "Spot mode", the dis-
play shows "Please place inside the
boundary and try again". Set the mower
down inside the boundary wire (11) and
next to the charging station and restart
"Spot mode".