Setting The Date And Time; Setting The Rain Sensor; Setting The Operating Times - Parkside PMRDA 20-Li A1 Originalbetriebsanleitung

If the battery charge level is less
than 30 %, the display shows "Low
battery voltage" after 2 seconds. Charge
the lawn mower before you can start mow-
ing with the fi xed point.

Setting the date and time

1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Confi rm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select
"Date and time".
7. Confi rm the selection with the OK but-
ton (7).
8. Change the date and time with the
arrow buttons (6). The individual po-
sitions can be navigated with the OK
button (7) (skip the right).
The correct date and time setting is
required to ensure the correct func-
tion of the operating time settings.

Setting the rain sensor

Never operate the lawn
mower during storms and
make sure to disconnect the charg-
ing station from the mains.
If the rain sensor is switched on, the lawn
mower returns to the charging station when
it rains.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Confi rm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select
"Rain mode".
7. Confi rm the selection with the OK but-
ton (7).
8. To deactivate the rain sensor, select "De-
activate" and confi rm the selection with
the OK button (7).
To activate the rain sensor, select "Acti-
vate" and confi rm the selection with the
OK button (7).
Select a time in minutes when
the lawn mower should start op-
erating again after the rain.
Decide also whether the lawn mower
should make up for the break in operating
time caused by the rain.
Confi rm each selection with the OK
button (7).
9. Return to the main menu with the back
button (5).
We advise against having the lawn
mower operate while it is raining.

Setting the operating times

1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. Press the OK button (7) to enter the
main menu.
4. Use the arrow buttons (6) to select "Set-
tings".
5. Confi rm the selection with the OK but-
ton (7).
6. Use the arrow buttons (6) to select "Op-
erating time".
GB MT
63