Charging The Battery; Checking The Charge Level Of The Battery; Working Instructions; Setting The Cutting Height - Parkside PMRDA 20-Li A1 Originalbetriebsanleitung

Charging the battery

The lawn mower automatically returns to
the charging station when it has a low
charge status. To do so, the lawn mower
locates the nearest boundary wire and fol-
lows this in a clockwise direction.
You can also place the lawn mower
in the charging station yourself.
Risk of injury! Press the STOP button
(9) before picking up the mower!
After the battery is fully charged, the
charging process stops and the lawn mow-
er switches to standby mode.
Graphical symbols on the charging
station
LED illuminated red:
Battery charging
LED illuminated green:
Battery charged
LED not illuminated: Charging station not
connected to power
Checking the charge level of
the battery
You can check the charge status of the
lawn mower on the display at any time.
1. If necessary, open the cover (1).
2. Unlock the display (10) with the 4-digit
PIN (factory setting "1111").
3. The charge status is now shown by the
battery symbol at the top right.
LED fl ashing green:
Boundary wire dam-
aged or incorrectly
connected
4. Press the START button (3) and close
the cover (1) again. The lawn mower
resumes its previously interrupted activi-
ty.
It is also possible to read the charge
level without unlocking the display,
but it is easier when the display is un-
locked.

Working instructions

Regular mowing stimulates the grass to an
increased leaf formation, while at the same
time killing weeds. As a result, the lawn
becomes denser after each mowing and
an evenly resilient lawn is created.
The fi rst cut takes place roughly in April
when the grass is about 7 - 8 cm high. Dur-
ing the main growing season, the lawn is
mowed at least once a week.

Setting the cutting height

Switch off the device and wait for
the blades to come to a stop. There
is a risk of personal injury.
1. Open the cover (1).
2. Set the rotary wheel (2) to the desired
cutting height.
3. Close the cover (1) again.
The device can be adjusted in 15 steps to
a cutting height between 25 - 60 mm.
The correct cutting height is between 30
and 45 mm for an ornamental lawn and
about 30 to 65 mm for a utility lawn.
A high cutting height should be se-
lected for the fi rst cuts in the season.
GB MT
67