Error Messages - Cube GO SwissDrive Betriebsanleitung

The combination of the motor symbol and the thermometer thus notifies you that the
motor is overheating (1), and the combination of the battery symbol and the thermom-
eter correspondingly warns you that the battery is overheating (2).
Adapt your riding style and/or the levels of drive assistance accord-
i
ing to these warnings if you wish to avoid a temporary reduction in or
even a complete loss of the drive assistance.
30
1 2
8.5.2 error messages
categorized error messages for the system can likewise be shown on the display.
The explanations for the error number are given in the error codes table below.
Error code Cause and possible correction
error 20 Unexpected communication from the bus. restart the
system.
error 22-27 control element cannot send on the bus. Unplug the mo-
tor and/or battery and plug them back in again. check that
the plugs and contacts are oK.
error 40 a bus sharing unit does not reply correctly in terms of tim-
ing.
error 41-43 Transmission error by bus sharing unit. restart.
c0 error reply from the motor is missing. check the contact to the
motor.
Battery symbol Battery has no bus.
missing
flashing motor motor has generated an error message. restart the sys-
symbol "m" tem. Unplug and put back in the motor plug.
flashing battery Battery has generated an error message. restart the
symbol system. Unplug and put back in the battery.
flashing motor and System error, for example, switching off because the volt-
battery symbol age was too low.
Thermometer with (early warning of) overheating.
battery or motor
symbol
an error is shown on the display with its error number for two seconds after its occurs.
In addition to the error code, the battery or motor symbol is shown flashing.
flashing of the battery or motor symbol means an error.
If you could not read the error message in the two second interval, you can call up the
last error from the display menu. Do this by going into the sub-menu of the display as
described in the section "Basic settings."
In the sub-menu, in addition to the setting options for the circumference of the tire and
the other functions there are also two sub-items labelled "err" and "berr." "err" and
the number shown indicate the last motor error, while "berr" and the number shown
indicate the last battery error. You can find an overview of the error messages in in
the above error codes table.
31