Before Every Ride; Safety Of Your Cube Pedelec/E-Bike; Display Of The State Of Charge; Deep Sleep Mode - Cube GO SwissDrive Betriebsanleitung

Never touch the motor or the rear wheel while using your CUBE
g
pedelec/e-bike.
Keep in mind that pedestrians do not hear you when you approach
G
at high speed. Therefore, ride particularly defensive and anticipating
when using cycle lanes and cycle/footpaths to avoid accidents. If nec-
essary, use the bell early enough to warn others.
Please respect nature when riding off-road. Only use your CUBE
i
pedelec on signposted, well maintained trails and hard-surface roads.
For your own safety, never do work on your CUBE pedelec unless you
g
feel absolutely sure about it. If you are in doubt or if you have any
questions, please contact your CUBE bicycle dealer.
Read in any case the detailed general bicycle user manual that you
I
have received from your CUBE bicycle dealer.
12
1 2
6. Before everY rIDe
6.1 Safety of your cUBe pedelec/e-bike
check the proper functioning and safety of your cUBe pedelec/e-bike each time
before every ride. You can find details on the required steps in your general bicycle
user manual. If you have any doubts, contact your cUBe bicycle dealer before your
first ride.
6.2 Display of the state of charge
The charge state can be read from your display (1). It is displayed in five bars (2) that
correspond to charging capacity of 100%. 4 bars correspond for 90% capacity, 3 bars
to 70%, 2 bars to 50%, 1 bar to 30% and 0 bars to 10% capacity.
We recommend that you recharge the battery after each longer ride so that you can
always get to your destination with full drive assistance and to extend the life of the
battery as long as possible. a good rule of thumb is that you should recharge the
battery when only three bars light up. You can find further information on the control
element in the section "Battery and charging".
6.3 Deep Sleep mode
Using the button under the saddle, you can either wake up the battery from Deep
Sleep mode or else put into that mode.
- If you hold down the button under the saddle for a short time (3) the battery
wakes up from Deep Sleep mode. The leD under the saddle lights up for 5 sec-
onds.
- If you hold down the button under the saddle for more than 8 seconds and then
release it, the battery goes into Deep Sleep mode. The leD (4) then flashes for
a period of 5 seconds as confirmation.
3 4
13