Control Element; Button Functions; Basic Settings - Cube GO SwissDrive Betriebsanleitung

8. coNTrol elemeNT
The control element (1) is a means to communicate with the drive system.
here you have a means that is within easy reach to switch the system on and off, to
select the level of drive assistance, and to view various items of information on the
system.
The control element is protected against dust and spraying water to
i
the IP 64 standard. However, it is still necessary to protect the display
against strong wind and penetrating moisture by means of a suitable
covering when transporting the pedelec on a bicycle carrier.
8.1 Button functions
The following describes the various buttons and display functions of the control ele-
ment.
The Start button (2) activates the entire drive system. The display should light up
shortly after you press this button and the entire system should be ready for use.
22
By using the + button (3) you can increase the assistance level of the drive system
and reduce it by means of the – button (4).
1
3
2
4
The drive system offers five assistance levels and three recuperation levels (the feed-
ing back of recovered energy into the battery and motor braking).
Press the mode button (5) to cycle through the various display functions on your
travelling data in the lower line of the display.
The Speed button (6) activates the pushing or starting aid and accelerates the bicycle
up to a set speed (max. 6 km/h).
The pushing and starting aid for CUBE S-Pedelecs accelerates up to a
A
maximum of 20 km/h.
8.2 Basic settings
The control element of your Go SwissDrive system gives you a great deal of infor-
mation and a high degree of convenience. It is necessary to make at least a certain
number of settings before the first ride to be able to guarantee these properties.
If possible, have this adjustment done when you collect your pedelec/
i
e-bike from the CUBE bicycle dealer.
5 6
23