Alarm Settings; Repeater Function - Sygonix 2523277 Bedienungsanleitung

13.5 Alarm settings

Click on the right mouse button and select the topmost item in the menu that appears to switch to the main menu.
The alarm settings can be accessed via the button with the exclamation mark in the hexagon on the left.
Now click on the left button with the exclamation mark in the square on the right-hand side. The configuration page
for the alarm function will open.
The alarm, motion detection, person and face recognition are enabled automatically by default. Person and face
recognition can be enabled and disabled separately by checking the checkboxes. Motion detection is automatically
enabled when the alarm is switched on.
Configuration:
Firstly, select the desired channel from the drop-down menu at the top left.
To disable the alarm for this channel altogether, uncheck the box at the top right.
The same applies to person and face recognition. To disable person and face recognition, uncheck the corre-
sponding box (2 lines).
For person and face recognition, you can choose whether the camera should start recording, whether you should
receive a notification in the app and whether an alarm should be triggered by checking the checkboxes.
Use the two buttons below to access the advanced settings for person and face recognition.
You can adjust and activate various settings, such as the alarm sound or voice output, taking a photo, sending an
e-mail (e-mail must be configured in the network settings), etc.
You can also set the detection sensitivity under the square on the left. There are 6 levels to choose from. The high-
er the sensitivity, the shorter the alarm triggering time. Naturally, a higher sensitivity also means a higher error rate.
Use the right button to set the alarm triggering rules. Here you can also define warning lines and ranges.
After configuring all settings, confirm with "OK".

13.6 Repeater function

The wireless surveillance set has a repeater function. Each camera passes the signal on to the next camera. This
significantly extends the range.
By default, the repeater function is set to automatic. You can change the settings as follows:
Open the camera settings (right mouse button + second button from the top) and then click on the right button
directly below the camera list.
Then click on the camera button to adjust the settings.
After changing a setting, wait a few seconds for it to take effect. You can also update the settings by clicking on
the button at the bottom left.
Finally, click on "OK".
67