D) Set Relay Delay Time (Door Opening Time); E) Exit Programming Mode; Restore Factory Settings (Reset); Maintenance And Cleaning - Sygonix 43904X Bedienungsanleitung

d) Set relay delay time (door opening time)

Make sure that the access system is in the programming mode.
The relay delay time (=door opening time) can be set between 0 and 10 seconds. The default fac-
tory setting is 5 seconds. The relay delay time (=door opening time) can be edited/adjusted using
the infrared remote control. Enter the following key combination to do so:
4 XX # *
XX stands for the relay delay time (=door opening time) in seconds (=0 to 10 seconds). If the fi gure
0 is assigned, the delay time is 50ms.

e) Exit programming mode

You can exit the programming mode by pressing the *key on the infrared remote control.
Please note that the device exits the programming mode automatically if there is
no input for 60 seconds.

14. Restore factory settings (RESET)

Proceed as follows to restore factory settings:
• Switch off the access system's mains voltage.
• Press and hold down the "RESET" button (see section "7 Explanation of Connections and But-
tons") and switch on the mains voltage again.
• An alarm signal will sound. The factory settings have been reset.
Only the user data has been kept.

15. Maintenance and cleaning

Other than changing the batteries no other parts require maintenance.
To clean the outside of the casing, a dry, soft and clean cloth is suffi cient. Do not use any aggres-
sive cleaning agents.
33